DGS-6604 ipv6 router rip
CLI Reference Guide
369
ipv6 router rip
To enable the IPv6 RIP routing process on an interface, use the ipv6 router rip
command. To disable the IPv6 RIP routing process on an interface, use the no
form of this command.
ipv6 router rip
no ipv6 router rip
Syntax None
Default Disabled
Command Mode Interface configuration
Usage Guideline The ipv6 router rip interface configuration command is used to enable IPv6 RIP
explicitly on required interfaces. In IPv4, the network network-number router
configuration command is used to implicitly specify the interfaces on which to run
IPv4 RIP.
Example The following example enables the IPv6 RIP routing process on VLAN 1.
Switch > enable
Switch # configure terminal
Switch (config)# interface vlan1
Switch (config-if)# ipv6 router rip
To Next Page
Loading...
