DGS-6604 m qos map dscp-color
CLI Reference Guide
512
qos map dscp-color
To define the DSCP to color map for mapping of packet's initial color, use the qos
map dscp-color command in interface configuration mode. To return the map to
the default setting, use the no form of this command.
qos map dscp-color DSCP-LIST to { green | yellow | red}
no qos map dscp-color
Default DSCP-LIST: 0-63 mapped to green
Command Mode Interface configuration
Usage Guideline Only physical ports are valid for this command.
When a packet enters the ingress port, it will be colored based on either the
DSCP to color map (as the port is trust DSP) or CoS to color map (as the port is
trust CoS).
Use the qos map dscp-color command in interface configuration mode to
configure the DSCP to color map. If the ingress port is set to trust DSCP, the
received IP packet will be initialized to a color based on this map. The non-IP
packet will be initialized to a color based on the CoS to color map.
Example The following example defines DSCP61~63 as yellow color, others are green
color at eth 3.1.
Verify the settings by entering the show qos interface map command.
Syntax Description
dscp DSCP-LIST Specifies the list of DSCP code point to be mapped to a color. The range of
DSCP is 0 to 63. The multiple DSCP values in the list can be in the form 1, 2, etc.
separated by commas, a continuous list such as 2-7, or a mixed form 1, 2, 3-10,
63,etc.
Switch(config)# interface eth3.1
Swtich (config-if)# qos map dscp-color 61-63 to yellow
To Next Page
Loading...
