DGS-6604 m show ipv6 ospf border-routers
CLI Reference Guide
711
show ipv6 ospf border-routers
To display the ABRs and ASBRs for the IPv6 OSPF process, use the show ipv6
ospf border-routers command.
show ipv6 ospf [PROCESS-ID] border-routers
Default None
Command Mode User EXEC
Usage Guideline Use this command to display the ABRs and ASBRs information.
If PROCESS-ID is not specified, display all IPv6 OSPF processes.
Example This is a sample output from the show ipv6 ospf border-routers command.
The result after executing this command is as follows.
Syntax Description
PROCESS-ID (Optional) Internally used identification parameter for an IPv6 OSPF routing
process. It is locally assigned and can be any positive integer. A unique value is
assigned for each IPv6 OSPF routing process.
Switch > enable
Switch # show ipv6 ospf border-routers
OSPFv3 Routing Table (Process null)
Codes: i - Intra-area route, I - Inter-area route
i 47.65.49.111 [1] is directly connected, vlan49, ABR, Area 0.0.0.0
Total Entries: 1
To Next Page
Loading...
