DGS-6604 m show ipv6 ospf virtual-links
CLI Reference Guide
716
show ipv6 ospf virtual-links
To display parameters and the current state of IPv6 OSPF virtual links, use the
show ipv6 ospf virtual-links command.
show ipv6 ospf [PROCESS-ID] virtual-links
Default None
Command Mode User EXEC
Usage Guideline The information displayed by the show ipv6 ospf virtual-links command is useful
in debugging OSPF routing operations.
If PROCESS-ID is not specified, the command will display all IPv6 OSPF
processes.
Example The following is sample output from the show ipv6 ospf virtual-links command.
Syntax Description
PROCESS-ID (Optional) Internally used identification parameter for an IPv6 OSPF routing
process. It is locally assigned and can be any positive integer. A unique value is
assigned for each IPv6 OSPF routing process.
Switch > enable
Switch # show ipv6 ospf virtual-links
Virtual Link VLINK1 to router 10.76.37.3 is up
Transit area 0.0.0.1 via interface vlan2, instance ID 0
Local address 3ffe:4::30/128
Remote address 3ffe:2::10/128
Transmit Delay is 1 sec, State Point-To-Point,
Timer intervals configured, Hello 10, Dead 40, Retransmit 5
Hello due in 0DT0H0M2S
Adajcency state Full
To Next Page
Loading...
