DGS-6604 mm default-information originate (RIP)
CLI Reference Guide
148
default-information originate (RIP)
To generate a default route into Routing Information Protocol (RIP), use the
default-information originate command. To disable this feature, use the no
form of this command.
default-information originate
no default-information originate
Syntax None
Default Disabled
Command Mode Router configuration
Usage Guideline Issuing this command generates a default route into RIP. The metric will always
be one.
Example The following example shows how to generate a default route into RIP:
Verify the settings by entering the show running-config command.
Switch# configure terminal
Switch(config)# router rip
Switch(config-router)# default-information originate
To Next Page
Loading...
