DGS-6604 m show ipv6 general-prefix
CLI Reference Guide
704
show ipv6 general-prefix
This command is used to display IPv6 general prefix information. It is used the
show ipv6 general-prefix command.
show ipv6 general-prefix [PREFIX-NAME]
Default None
Command Mode User EXEC
Usage Guideline Use the show ipv6 general-prefix command to view information on IPv6
general prefixes.
Examples The following example shows how to display all IPv6 general prefixes on the
switch:
Syntax Description
PREFIX-NAME The name of the general prefix to be showed. If the general prefix name is not
specified, then all general prefixes on the system will be showed. The general
prefix name can be 1-16 characters.
Switch > enable
Switch # show ipv6 general-prefix
IPv6 prefix dhcp-prefix
Acquired via DHCP Client:
vlan1
Apply to interface:
vlan3
::3:3:3:3:3/64
vlan2
::4:4:4:4:4/64
::2:2:2:2:2/64
IPv6 prefix my-prefix
Acquired via Manual configuration:
3ffe:1:1::/48
Apply to interface:
vlan2
::1:1:1:1:1/64
To Next Page
Loading...
