DGS-6604 m show dot1x
CLI Reference Guide
596
show dot1x
Use this command to display information about the: 802.1X state, configuration,
statistics, diagnostics, session statistics, or authentication client.
show dot1x [interface INTERFACE-ID] {auth-state | auth-configuration | statistics |
diagnostics | session-statistics}
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline If a port is not specified, then information for all ports will be displayed.
Examples This example shows how to display the authentication configuration for port
eth4.1.
Syntax Description
interface
INTERFACE-ID
(Optional) Specifies a port to display the authentication state, configuration,
statistics, diagnostics, or session statistics. This option is only valid for a physical
port interface.
auth-state Display information of 802.1X state.
auth-configuration Display information of 802.1X configuration.
statistics Display information of 802.1X statistics.
diagnostics Display information of 802.1X diagnostics.
session-statistics Display information of 802.1X session statistics.
Switch#show dot1x interface eth4.1 auth-configuration
System Auth Control: Enabled
Authentication Protocol: Local
eth4.1
PAE: Authenticator
Control Direction: Both
Port Control: Auto
Quiet Period: 60
Tx Period: 30
Supp Timeout: 30
Server Timeout: 30
Max-req: 2
Reauth Period: 3600
Re-authentication: Disabled
Authentication Mode: Host-based
Guest VLAN: Disabled
Forward 1x PDU: Disabled
Total Entries: 1
To Next Page
Loading...
