D-Link DGS-6600-48TS

DGS-6604 m show snmp
CLI Reference Guide
750
show snmp
Use this command to display the SNMP information of the device.
show snmp {community | host | view | group | engineID}
Default None
Command Mode Privileged EXEC or any configuration mode
Usage Guideline This command displays the SNMP information.
Examples This example shows how to display SNMP community information.
This example is sample output from the command show snmp host.
Syntax Description
community Display SNMP community information.
host Display SNMP trap recipient information.
view Display SNMP view information.
group Display SNMP group information.
engineID Display SNMP local engine ID information.
Switch# show snmp community
Codes: ro - read only, rw - ReadWrite
(rw)System
(ro)public
(ro)Develop
(rw)private
Total Entries: 4
Switch#
Switch# show snmp host
Host IP Address SNMP Version Community Name SNMPv3 User Name
-------------------- ------------------ ----------------------- ----------------
10.48.76.100 v3 noauth initial
10.51.17.1 v2c public
20:64:84::154 v2c public
Total Entries: 3
Switch#