DGS-6604 bgp default ipv4-unicast
CLI Reference Guide
73
bgp default ipv4-unicast
Use this command to enable the IP version 4 (IPv4) unicast address family for all
neighbors. This affects the BGP global configuration. Use the no form of the
command to disable this function.
bgp default ipv4-unicast
no bgp default ipv4-unicast
Syntax None
Default bgp default ipv4-unicast
Command Mode Router configuration
Usage Guideline The bgp default ipv4-unicast command is used to enable the automatic
exchange of IPv4 address family prefixes.
Example This example shows how to configure BGP defaults and activate ipv4-unicast of
a peer by default for autonomous system 65534:
Switch(config)# router bgp 65534
Switch(config-router)# bgp default ipv4-unicast
To Next Page
Loading...
