DGS-6604 m show ddm status
CLI Reference Guide
591
show ddm status
This command displays the current operating parameters of the SFP modules.
show ddm status [INTERFACE-ID [, | -]]
Default None.
Command Mode EXEC mode or any configuration mode.
Usage Guideline It is possible to use this command to display the current operating parameters
values of the SFP module for the specified ports.
Example The following example shows how to display DDM statuses of all valid ports.
Syntax Description
INTERFACE-ID [, | -]] It is possible to specify multiple interfaces for DDM status displays. If no
INTERFACE-ID is specified DDM statuses on all valid interfaces are displayed.
Switch# show ddm status
Temperature Voltage Bias Current TX Power RX Power
port (Celsius) (V) (mA) (mW) (mW)
-------- ------------ ------------ ------------ ------------ ------------
eth2.1 23.129 3.372 0.000 0.0000 0.0000
eth3.25 32.539 3.292 5.220 0.5300 0.0641
eth3.26 31.328 3.302 5.408 0.5300 0.0659
To Next Page
Loading...
