DGS-6604 m power-saving
CLI Reference Guide
500
power-saving
Use the power-saving command to enable "Power Saving" function in the device.
And use the no form of this command to disable "Power Saving" function.
power-saving {phy}
no power-saving {phy}
Default Disabled
Command Mode Global configuration.
Usage Guideline The "power-saving" command can enable the "Power Saving" function on
different hardware components. Currently, one component is supported: phy.
Select the option "phy", it will set the PHY into "Power Saving" mode. The "no
power-saving" command disables this function.
The "PHY Power Saving" function could be enabled or disabled per-system
base. There are two operation modes: "low-power" mode and "normal" mode.
When power saving is enabled, the chips automatically enter "low-power" mode
if the signal from a copper link partner is lost. They will go to normal mode when
a signal is detected.
If "PHY Power Saving" function is disabled, PHY will always be in normal mode
no matter that the signal froma link partner is presented or not.
Example The following example shows how to enable/disable "Power Saving" function.
Switch(config)#power-saving
Switch(config)#
Switch(config)show power-saving
Power-saving status
============================
phy power-saving:Enabled
Switch(config)#no power-saving
Switch(config)#show power-saving
Power-saving status
============================
phy power-saving:Disabled
To Next Page
Loading...
