DGS-6604 m spanning-tree mst configuration
CLI Reference Guide
869
spanning-tree mst configuration
To enter MST-configuration submode, use the spanning-tree mst configuration
command. To return to the default settings, use the no form of this command.
spanning-tree mst configuration
no spanning-tree mst configuration
Syntax None
Default The default value for the MST configuration is the default value for all its
parameters:
• No VLANs are mapped to any MST instance (all VLANs are mapped to
the CIST instance).
• The region name is the Bridge MAC Address.
Command Mode Global configuration
Usage Guideline The MST configuration consists of three main parameters:
• Instance VLAN mapping-See the instance command
• Region name-See the name (MST configuration submode) command
• Configuration revision number-See the revision command
The exit command is used to leave MST configuration submode.
Changing an MST-configuration submode parameter can cause connectivity
loss. To reduce service disruptions, when entering the MST-configuration
submode, make changes first to a copy of the current MST configuration before
applying them at the submode.
.Examples This example shows how to enter MST-configuration submode:
This example shows how to reset the MST configuration to the default settings:
Switch(config)# spanning-tree mst configuration
Switch(config-mst)#
Switch(config)# no spanning-tree mst configuration
Switch(config)#
To Next Page
Loading...
