DGS-6604 m sflow poller
CLI Reference Guide
571
sflow poller
Use the sflow poller command to create/configure a Poller for the sFlow agent.
Use the no form of this command to delete one Poller or all Pollers.
sflow poller INSTANCE [receiver RECEIVER] [interval SECONDS]
no sflow poller [INSTANCE]
Default No Poller is created.
Command Mode Interface configuration mode.
Usage Guideline The command is available for physical port interface configuration.
A Poller can only be configured on one interface. It cannot be associated with
multiple interfaces.
Use this command without keywords to create a default Poller or to reset an
existing Poller to default values. Use the no form of this command with
INSTANCE to delete one Poller. Use the no form of this command without
INSTANCE to delete all Pollers.
The user can only specify a Receiver that has its owner name setup. If the
Receiver associated with the Poller has its owner name is reset, the Poller will be
reset to the default setting.
Setting the polling interval to 0 disables the polling.An interface can be
configured with multiple Pollers.
Example This example shows how to create/configure the Poller of INSTANCE 1 with
RECEIVER as 1, and INTERVAL as 20 seconds.
Syntax Description
INSTANCE The instance index if multiple pollers are associated with one interface. The
range is from 1 to 65535
receiver RECEIVER (Optional) The receiver's INDEX for this poller. If not specified, the value is 0. the
user cannot configure the value to 0. The maximum number is project
dependent.
interval SECONDS (optional) The maximum number of seconds between successive polling
samples. The range is from 0 to 120. 0 means disable. If not specified, the
default is 0.
switch(config-if)# sflow poller 1 receiver 1 interval 20
To Next Page
Loading...
