DGS-6604 m redistribute (RIP)
CLI Reference Guide
522
redistribute (RIP)
Use redistribute to redistribute routes from one routing domain into another
routing domain. Use the no form of the command to disable redistribution.
redistribute PROTOCOL [metric METRIC-VALUE]
no redistribute PROTOCOL
Default Disabled
PROTOCOL: Not configured
METRIC-VALUE: 0
Command Mode Router configuration
Usage Guideline Routes, configured with the connected keyword, affected by this redistribute
command are the routes not specified by the network router configuration
command.
Regarding the metric conversion, the following is the rule.
If the metric option is not specified, the following rules are applied:
1. If the metric is not specified, or is specified as 0, the metric for the redistrib-
uted static route or connected route will be 1.
2. If the metric is not specified, the metric for the redistributed route from other
protocols to RIP process will be determined by the value of the “default-met-
ric” command.
Syntax Description
PROTOCOL Source protocol from which routes are being redistributed. It can be one of the
following keywords: bgp, connected, ospf, static.
The static keyword is used to redistribute IP static routes.
The connected keyword refers to routes that are established automatically by
virtue of having enabled IP on an interface.
For routing protocols such as Open Shortest Path First (OSPF), these routes will
be redistributed as external to the autonomous system.
metric METRIC-
VALUE
(Optional) Specifies metric value to be used in redistributing information. The
range is 0 to 16. Regarding the metric conversion, the following is the rule.
1. If the metric is not specified, the metric for the redistributed route from other
protocols to the RIP process will be determined by the value of the "default-
metric" command.
2. If the metric is specified as 0, the metric for the redistributed route from other
protocols to the RIP process will be 1.
To Next Page
Loading...
