DGS-6604 m show ip pim interface
CLI Reference Guide
681
show ip pim interface
Use this command to show the interface information.
show ip pim interface [INTERFACE-ID] [detail]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline Use this command to display interface related information. If no interface is
specified, the PIM information on all applicable interfaces will be shown.
Examples The following example displays interface information.
On the following page is an example which displays the interface information in
detail.
Syntax Description
INTERFACE-ID (Optional) Specifies the interface to display the interface information for. Only
VLAN interface IDs are applicable.
detail (Optional) Use to display the interface information in detail.
switch #show ip pim interface
Address Interface Mode Neighbor DR DR Generation
Count Priorty ID
-------------- ---------- ------ -------- ------- -------------- ----------
90.1.1.1 vlan100 Sparse 1 1 90.1.1.1 164598300
30.1.1.1 vlan200 Dense 1 0 0.0.0.0 375693
Total Entries: 2
To Next Page
Loading...
