DGS-6604 m shutdown (Management Port)
CLI Reference Guide
790
shutdown (Management Port)
Use this command to disable the management port. Use the no form of the
command to turn the management port back to the enabled state.
shutdown
no shutdown
Syntax None
Default Enabled
Command Mode Management interface
Usage Guideline This command will disable the management port. Users cannot access or
manage the system using the management port until the no shutdown command
is executed.
Example Use the shutdown command to disable the Management Port.Verify the settings
by entering the show mgmt-if command.
Switch(config)#mgmt-if
Switch(mgmt-if)#shutdown
Switch(mgmt-if)#end
To Next Page
Loading...
