DGS-6604 m show port-security
CLI Reference Guide
740
show port-security
Use this command to display the current port security setting.
show port-security [interface INTERFACE-ID [, | -]] [address]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline If no interface ID is specified, the show port-security command will display the
port security setting of all existing port interfaces.
If the mac-address address option is specified, the configured and learned
secure MAC address entries will be displayed.
If no optional keyword is specified with show port-security command, all of the
port-security information is displayed.
Examples This example shows how to display the port security setting of interface port
eth4.1.
Syntax Description
INTEFACE-ID (Optional) Specifies the ID of interfaces to display.
, (Optional) Specifies a series of interfaces, or separate a range of interfaces from
a previous range. No space before and after the comma.
- (Optional) Specifies a range of interfaces. No space before and after the hyphen.
address (Optional) Display all the secure MAC addresses including both of configured
and learned entries.
DGS-6600:15#show port-security interface eth4.1
Interface Max No. Current No. Violation Secure Type State
---------------------------------------------------------------------------
eth4.1 1 0 Shutdown Delete-on-Timeout Disabled
Total Entries: 1
To Next Page
Loading...
