DGS-6604 ip http service-port
CLI Reference Guide
265
ip http service-port
Use this command to specify the HTTP service port. And use the default
command to return the service port to 80.
ip http service-port TCP-PORT
default ip http service-port
Default Port 80
Command Mode Global configuration
Usage Guideline This command configures the TCP port number for HTTP.
Example This example set HTTP TCP port number to 100
Verify the settings by entering the show system protocol-state command.
Syntax Description
TCP-PORT TCP port number. TCP ports are numbered between 1 and 65535. The "well-
known" TCP port for the HTTP protocol is 80.
Switch(config)# ip http service-port 100
To Next Page
Loading...
