DGS-6604 ip address (management port)
CLI Reference Guide
228
ip address (management port)
Use the command to set the IP address of the Management Port. Use the no
form of this command to revert to the default IP address.
ip address IP-ADDRESS / PREFIX-LENGTH
no ip address
Default 10.90.90.90/8.
Command Mode Management interface configuration
Usage Guideline This is the IP address used for management access to the system. Use no ip
address command to restore the default IP address 10.90.90.90/8.
Example This example shows how to set 10.1.1.1 as the IP address of the Management
Port.
Verify the settings by entering the show mgmt-if command.
Syntax Description
IP-ADDRESS IP address to be configured for the Management Port.
PREFIX-LENGTH Prefix Length.
Switch#configure terminal
Switch(config)#mgmt-if
Switch(mgmt-if)#ip address 10.1.1.1/8
Switch(mgmt-if)#end
To Next Page
Loading...
