D-Link DGS-6600-48TS

DGS-6604 m show ip policy
CLI Reference Guide
804
show ip policy
Use the command to display the route map used for policy based routing.
show ip policy
Syntax Not applicable.
Default Not applicable.
Command Mode EXEC mode.
Usage Guideline The user can use the command to display the policy based routing configured on
interfaces.
Example The following is sample output from the show ip policy command:
Switch#show ip policy
Interface Route-map
------------ --------------------
vlan1 pbr-map1
Vlan2 pbr-map2
Vlan100 pbr-map3
Switch#