DGS-6604 m show interface status err-disabled
CLI Reference Guide
612
show interface status err-disabled
Use this command to display a list of interfaces in an error-disabled state, use
the show interfaces status errdisable command.
show interface status err-disabled
Syntax
Description
None
Default None
Command Mode EXEC mode or any configuration mode.
Usage Guideline You can use this command to verify which interfaces has been disabled because
of an error condition.
Example This example shows how to display the information about the error-disable
recovery timer.
Switch# show interface status err-disabled
Interface Status Reason
--------- ----------------- --------------
eth2.8 err-disabled loopback-detection
eth4.17 err-disabled loopback-detection
eth3.10 err-disabled loopback-detection
To Next Page
Loading...
