DGS-6604 m show ip protocols
CLI Reference Guide
689
show ip protocols
Use this command to display the state of the dynamic routing process.
show ip protocols [rip] [ospf] [bgp]
Default If no option is specified, the summary of all running routing protocols is displayed.
Command Mode User EXEC or any configuration mode
Usage Guideline The information displayed by the show ip protocols command is useful when
debugging routing operations. The output can help identify a router suspected of
delivering faulty routing information.
Examples The following example shows how to output the state of the RIP protocol:
Syntax Description
rip (Optional) RIP protocol information is displayed.
ospf (Optional) Display OSPF global settings which are related to the overall IP
routing function.
bgp (Optional) Display entries in the Border Gateway Protocol (BGP) routing table.
Specifies the autonomous system to be displayed. .
Switch# show ip protocols rip
Routing Protocol is "rip"
Sending updates every 30 +/- (0 to 5) seconds, next due in 19 seconds
Timeout after 180 seconds, garbage collect after 120 seconds
Default redistribution metric is 1
Redistributing:
type metric
------------------------
Default version control: send version 2, receive version 2
Interface Send Recv V2-broadcast Key-chain
vlan141 2 2 Off
Routing for Networks:
vlan141 (10.253.41.2/24)
Routing Information Sources:
Gateway Distance Last Update Bad Packets Bad Routes
10.253.41.1 120 0DT0H0M11S 0 1
the maximum number of RIP routes allowed: 12288
Number of routes (excluding connected): 3
Distance: (default is 120)
Switch#
To Next Page
Loading...
