DGS-6604 m gvrp advertise (VLAN)
CLI Reference Guide
212
gvrp advertise (VLAN)
Use the gvrp advertise command to specify that this VLAN will be advertised
out by GVRP protocol. Use no gvrp advertise to disable this function.
gvrp advertise
no gvrp advertise
Syntax None
Default Advertise is enabled
Command Mode Config-VLAN configuration
Usage Guideline If a VLAN has been configured to be advertised under the config-VLAN mode,
GVRP protocol will advertise this VLAN if it has any member ports. However the
command takes effect only in the running configuration, it is not stored in NV-
RAM for the next start up configuration. In the interface mode, the command is
stored in NV-RAM for next startup system configuration mode.
Example This example shows how to configure VLAN 1000 to be advertised.
Verify the settings by entering the show gvrp configuration command.
Switch(config)# VLAN 1000
Switch(config-VLAN)# gvrp advertise
To Next Page
Loading...
