DGS-6604 m show ip pim rp mapping
CLI Reference Guide
687
show ip pim rp mapping
Use this command to show group-to-RP (rendezvous point) mappings, and the
RP set.
show ip pim rp mapping
Syntax None
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline Use this command to display active rendezvous points (RPs) that are cached
with associated multicast routing entries.
This command is used to display the RP mapping information viewed by the
router
Example The following is sample output from the show ip pim rp mapping command with
the group address 239.1.1.1 specified:
Display Field
Descriptions
The table below shows the ip pim rp mapping detailed field descriptions.
Switch#show ip pim rp mapping
PIM Group-to-RP Mappings
Group(s): 224.0.0.0/4
RP: 90.1.1.3
Info source: 90.1.1.3, via bootstrap, priority 0
Uptime: 0DT16H52M39S, expires: 0DT0H2M50S
Field Descriptions
RP Address of the RP for the group specified.
Info source Indicates from which system the router learned this RP information. RP was
selected by the bootstrap mechanism. In this case, the BSR is also the RP.
Via bootstrap The RP mapping information is learned from RP.
Priority The RP priority
Uptime Length of time that the router has known about this RP.
Expires Time after which the information about this RP expires. If the router does not
receive any refresh messages in this time, it will discard information about this
RP.
To Next Page
Loading...
