DGS-6604 m area stub (IPv6)
CLI Reference Guide
46
area stub (IPv6)
To set the summary-default cost of a stub area, use the area default-cost
command. To disable this function, use the no form of this command.
area AREA-ID stub [no-summary]
no area AREA-ID stub [no-summary]
Default Disabled
Command Mode Router configuration
Usage Guideline This command is used only on an ABR attached to a stub area. In all routers and
access servers attached to the stub area, the area should be configured as a
stub area using the area stub command. Use the area default-cost (IPv6)
command on page 40 only on an ABR attached to the stub area. The area
default-cost command provides the metric for the summary default route
generated by the ABR into the stub area.
Use the no-summary argument with this command to define a totally stubby
area. When routers in the area do not require to learn about summary LSAs from
other areas, then a totally stubby area should be defined. To define a totally
stubby area configure the ABR of that area using the area stub no-summary
command.
Examples In the following example, the area stub command is used to configure the router
as a stub that advertises connected and summary routes.
Syntax Description
AREA-ID Identifier of the area about which routes are to be summarized. It can be
specified as either a decimal value or as an IPv4 address.
no-summary (Optional) Prevent an ABR from sending summary link advertisements into the
stub area.
Switch > enable
Switch # configure terminal
Switch (config) # router ipv6 ospf
Switch (config-router)# router-id 20.0.1.10
Switch (config-router)# area 1 stub
To Next Page
Loading...
