DGS-6604 m erpi rpl
CLI Reference Guide
199
erpi rpl
Use the erpi rpl command to configure an ERP instance as the RPL owner and
the RPL port. Use the no form of this command to remove the RPL related
setting.
erpi INSTANCE-ID rpl owner rpl-port {east | west }
no erpi INSTANCE-ID rpl
Default Not configured
Command Mode ERPS domain configuration mode
Usage Guideline Use the command to specify one of the nodes in the ring as the RPL owner, and
one of its ring ports as the RPL port.
The setup of the RPL owner and RPL port are required for operation of the ring.
Example The following example shows how to enable RPL owner and configure RPL port
to east ring port of ERP instance 1:
The following example shows how to enable RPL owner and configure RPL port
to west ring port (non-shared) of ERP instance 2:
The following example shows how to disable RPL owner of ERP instance 1:
Syntax Description
INSTANCE-ID Specifies the identifier of ERP instance. The valid range is 1 to 4095.
owner Specifies the ring node as the RPL owner of the ERP instance.
rpl-port Specifies one of the ring ports as the RPL port.
Switch(config-erps-domain)# erpi 1 rpl owner rpl-port east
Switch(config-erps-domain)#
Switch(config-erps-domain)# erpi 2 rpl owner rpl-port west
Switch(config-erps-domain)#
Switch(config-erps-domain)# no erpi 1 rpl
Switch(config-erps-domain)#
To Next Page
Loading...
