DGS-6604 m redistribute
CLI Reference Guide
517
redistribute
Use redistribute to redistribute routes from one routing domain into BGP. Use no
command to disable route redistribution.
redistribute PROTOCOL [route-map MAP-NAME]
no redistribute PROTOCOL
Default Route redistribution is disabled.
Command Mode. Router configuration
Address family configuration
Usage Guideline Note: The user can use the command to redistribute prefix from different
sources to BGP protocol.
Example The following example redistributes the OSPF process routes into BGP process.
You can verify your settings by entering the show ip protocols bgp command.
Syntax Description
PROTOCOL Specifies the protocol whose routes are to be redistributed. It can be one of the
following keywords connected, ospf, rip static.
The static keyword means to redistribute IP static routes.
The connected keyword refers to routes that are established automatically by
virtue of having enabled IP on an interface.
route-map MAP-
NAME
(Optional) Specify the identifier of a route map used to filter the networks to be
redistributed. If not specified, all networks are advertised.
Switch(config)# router bgp 8001
Switch(config-router)# redistribute ospf
Switch(config-router)# end
Switch#
To Next Page
Loading...
