DGS-6604 ip dhcp screening suppress-duration
CLI Reference Guide
236
ip dhcp screening suppress-duration
Used to set the suppressed duration for trap/log and use the no form of this
command to restore back to default setting.
ip dhcp screening suppress-duration SUPPRESS-TIME
no ip dhcp screening suppress-duration
Default 10 minutes
Command Mode Global configuration mode
Usage Guideline Use this command to set the interval that device will send trap when illegal
DHCP server is detected. The same illegal DHCP server IP address detected
just is send once to the trap receivers within the specified ceasing unauthorized
duration.
Example The following example shows to specify the suppress time to 20 minutes:
Syntax Description
SUPPRESS-TIME The monitoring interval
The valid value is between 1 and 30.
Default value: 10 minutes
Until: minute.
switch#configure terminal
switch(config)# ip dhcp screening suppress-duration 20
To Next Page
Loading...
