DGS-6604 ip rip authentication key-chain
CLI Reference Guide
313
ip rip authentication key-chain
Use this command to enable authentication for RIP Version 2 packets and to
specify the key that can be used on an interface. To prevent authentication, use
the no form of this command.
ip rip authentication key-chain NAME-OF-KEY
no ip rip authentication key-chain
Default No authentication is provided for RIP packets.
Command Mode Interface configuration
Usage Guideline If no key is configured with the key-chain command, no authentication is
performed on the interface.
This command also specifies that the interface will use the key chain for
authentication.
Syntax Description
NAME-OF-KEY Enables authentication and specifies the key that are valid.
To Next Page
Loading...
