D-Link DGS-6600-48TS

DGS-6604 m lldp dot1-tlv-select
CLI Reference Guide
382
lldp dot1-tlv-select
To specify which optional type-length-value settings (TLVs) in the IEEE 802.1
Organizationally Specific TLV set will be transmitted and encapsulated in the
LLDPDUs and sent to neighbor devices, use the lldp dot1-tlv-select command in
interface configuration mode. To disable transmit the TLVs, use the no form of
this command.
lldp dot1-tlv-select {port-vlan | protocol-vlan VLAN-ID [, | -] | vlan-name [VLAN-ID [, | -]] |
protocol-identify [PROTOCOL-NAME]}
no lldp dot1-tlv-select {port-vlan | protocol-vlan [VLAN-ID [, | -] ] | vlan-name [VLAN-ID [, | -]] |
protocol-identify [PROTOCOL-NAME]}
Syntax Description
port-vlan
Specify the Port Vlan ID TLV to send. The Port VLAN ID TLV is an optional
fixed length TLV that allows a VLAN bridge port to advertise the port’s VLAN
identifier (PVID) that will be associated with un-tagged or priority tagged frames.
protocol-vlan VLAN-
ID [, | -]
Specify the Port And Protocol VLAN ID (PPVID) TLV to send. The Port and
Protocol VLAN ID TLV is an optional TLV that allows a bridge port to advertise a
port and protocol VLAN ID.
VLAN-ID [, | -] Specify the ID of the VLAN in the PPVID TLV. The VLAN ID range
is 1 to 4094. Separate nonconsecutive VLAN-ID with a comma; use a hyphen to
designate a range of VLAN-ID.
In no form of this command, the VLAN-ID [, | -] is optional. If no VLAN-ID is
specified, all configured PPVID VLANs will be cleared and no PPVID TLV will be
sent.
vlan-name [VLAN-ID
[, | -]
Specify the VLAN Name TLV to send. The VLAN Name TLV is an optional TLV
that allows an IEEE 802.1Q-compatible IEEE 802 LAN station to advertise the
assigned name of any VLAN with which it is configured.
VLAN-ID [, | -] (Optional) Specify the ID of the VLAN in the VLAN Name TLV. The
VLAN ID range is 1 to 4094. Separate nonconsecutive VLAN-ID with a comma;
use a hyphen to designate a range of VLAN-ID. If no VLAN-ID is specified, all
applicable VLANs will be sent.
In no form of this command, if no VLAN-ID is specified, all configured VLANS for
VLAN NAME TLV will be cleared and no VLAN Name TLV will be sent.