DGS-6604 m router ospf
CLI Reference Guide
537
router ospf
To configure an Open Shortest Path First (OSPF) routing process, use the router
ospf command in global configuration mode. To terminate an OSPF routing
process, use the no form of this command.
router ospf
no router ospf
Syntax None
Default Not configured
Command Mode Global configuration
Usage Guideline This command is used to enable OSPF routing processes and enter into router
configuration mode then other OSPF-related settings can be configured.
Example This example shows how to enable ospf and enter the ospf router configuration
mode.
Verify the settings by entering the show ip protocols ospf command.
Switch# configure terminal
Switch(config)# router ospf
Switch(config-router)#
To Next Page
Loading...
