DGS-6604 m show loopback-detection
CLI Reference Guide
725
show loopback-detection
Use the command to show the current loopback detection control settings.
show loopback-detection [interface [INTERFACE-ID] [, | -]
Default None
Command Mode EXEC mode or any configuration mode
Usage Guideline Show the loopback detection information.
Example This example shows current loopback detection setting and running status for
port-based mode.
Syntax Description
<cr> To show all the loopback detection protocol information.
interface
INTERFACE-ID
Specify the interface-ID which you want to display.
, (Optional) Specify a series of interfaces, or separate a range of interfaces from a
previous range. No space before and after the comma.
- (Optional) Specify a range of interfaces. no space before and after the hyphen.
detail (Optional) Displays detailed information about spanning-tree state.
Switch# show loopback-detection
Status : Enabled
Mode : Port-Based
Interval : 20 s
Interface LoopDetect State Result Time Left(sec)
------------- --------------------- ----------------- --------------
eth3.1 Enabled Normal
eth3.8 Enabled Normal
eth4.5 Enabled Loop 20
To Next Page
Loading...
