DGS-6604 m show traffic-segmentation
CLI Reference Guide
771
show traffic-segmentation
Use this command to show the traffic segmentation for some ports or all ports.
show traffic-segmentation [interface INTERFACE-ID [ , | - ]]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline The allowable interface types for this command are either physical ports or port
channels.
If entering show traffic-segmentation without any keywords, then the traffic
segmentation configuration for all ports is displayed. Otherwise, only the
specified interface's traffic-segmentation is shown.
Example This example shows the configuration of traffic segmentation for eth3.1
Syntax Description
interface
INTERFACE-ID
(Optional) Specifies the ID of an interface. The allowable interfaces are either
physical ports or port channels.
, (Optional) Specifies a series of interfaces, or separate a range of interfaces from
a previous range. No space before and after the comma.
- (Optional) Specifies a range of interfaces. No space before and after the hyphen.
Switch# show traffic-segmentation interface eth3.1
Interface Forwarding Interface(s)
----------------------------------------
eth3.1 eth3.1, eth3.4, eth3.5, eth3.6
Total Entries: 1
To Next Page
Loading...
