DGS-6604 m show ip igmp snooping group
CLI Reference Guide
647
show ip igmp snooping group
Use this command to display IGMP Snooping group information learned by the
switch.
show ip igmp snooping group [IP-ADDRESS | VLAN VLAN-ID] [detail]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline User can display IGMP Snooping group information by this command. The
following examples cover different versions of the IGMP.
If the specified VLAN does not exist or IGMP Snooping is disabled at the VLAN,
an error message will be displayed instead.
Examples This example shows how to display IGMP Snooping group information.
Display Field
Descriptions
show ip igmp snooping group Field Descriptions.
Syntax Description
IP-ADDRESS (Optional) Specifies the Group IP address to display. If no IP address is
specified, all IGMP Snooping group information will be displayed.
VLAN VLAN-ID (Optional) Specifies the VLAN interface to display. If no VLAN is specified, the
command shows IGMP snooping group information about all VLANs where
IGMP Snooping is enabled.
detail (Optional) Specifies to show the additional information (Uptime, Expires, Group
mode and Last reporter).
Switch# show ip igmp snooping group
IGMP Snooping Connected Group Membership: ((s)- static configuration)
Group address Source address Interface Port
------------- --------------- -------- ---------
224.0.1.149 10.2.2.18 vlan1 eth3.12
224.0.1.145 10.1.1.2 vlan1 eth3.15
224.0.2.123(s) 10.3.3.128 vlan2 eth3.1
Total Entries : 3 entries, 6 records
Field Description
entries The number of the igmp snooping group table display.
records The number of the group records and source records in the igmp snooping
group table.
To Next Page
Loading...
