DGS-6604 m arp timeout
CLI Reference Guide
54
arp timeout
Use the arp timeout command to set the ARP aging time for the ARP table.
arp timeout SECONDS
Default 14400 seconds (4 hours)
Command Mode VLAN interface configuration
Usage Guideline Only VLAN interfaces are valid for this command.
Example This example shows how to set the ARP timeout to 12000 seconds to allow
entries to time out faster than the default setting:
Verify the settings by using show ip interface command
Syntax Description
SECONDS Number of seconds that dynamic entries will remain in the ARP table before
being deleted; valid values are from 0 to 65535.
Switch(config)# interface vlan1
Switch(config-if)# arp timeout 12000
To Next Page
Loading...
