DGS-6604 interface
CLI Reference Guide
221
interface
Enter the interface command to go into interface configuration mode. The
command executed in this mode will be applied to the interface specified by the
command.
interface INTERFACE-ID
Default None
Command Mode Global configuration
Usage Guideline The interface command puts the command line interface into interface
configuration mode for a specified interface.
For the port-channel interface, it must be an existing channel-group.
For the VLAN interface, it must be a previously created VLAN.
Example This example shows how to enter the interface configuration mode for eth2.5:
Syntax Description
INTERFACE-ID The interface can be a physical port, port-channel, or VLAN.
Switch(config)# interface eth2.5
Switch(config-if)#
To Next Page
Loading...
