DGS-6604 m snmp-server contact
CLI Reference Guide
844
snmp-server contact
Use this command to configure the system’s snmp contact information. Use the
no form of this command to remove the configuration of system contact
information.
snmp-server contact TEXT
no snmp-server contact
Default None
Command Mode Global configuration
Usage Guideline Configures the system’s snmp contact information on the switch.
Example This example shows how to set the system’s snmp contact information as the
string MIS Department II.
Verify the settings by entering the show snmp-server command.
Syntax Description
contact TEXT String that describes the system contact information.The maximum length is 255
characters (please refer to RFC1213 for the maximum length in detail). The
syntax is a general string that allows space.
Switch(config)# snmp-server contact MIS Department II
To Next Page
Loading...
