DGS-6604 m erpi protected-vlan
CLI Reference Guide
200
erpi protected-vlan
Use the erpi protected-vlan command to add or remove service protected VLANs
for an ERP instance. Use the no form of this command to remove all service
protected VLANs.
erpi INSTANCE-ID protected-vlan {VLAN-ID [,|-] | add VLAN-ID [,|-] | remove VLAN-ID [,|-]}
no erpi INSTANCE-ID protected-vlan
Default Not configured
Command Mode ERPS domain configuration mode
Usage Guideline Use the command to configure the VLANs to be protected by the ERP instance.
The user should assign the service protected VLANs that are distinguished from
the R-APS control VLAN of all created ERP instances.
If an ERPS domain contains multiple ERP instances, generally, the VLANs
protected by them should be consistent.
Example The following example shows how to configure service protected VLAN as 3 of
ERP instance 1:
The following example shows how to add service protected VLANs "4-6" of ERP
instance 1:
The following example shows how to add service protected VLANs "7,9" of ERP
instance 1:
The following example shows how to remove service protected VLAN "3" of ERP
instance 1:
Syntax Description
INSTANCE-ID Specifies the identifier of the ERP instance. The valid range is 1 to 4095
VLAN-ID Specifies the VLAN ID of the service protected VLANs of the ERP instance. The
valid range is 1 to 4094.
Switch(config-erps-domain)# erpi 1 protected-vlan 3
Switch(config-erps-domain)#
Switch(config-erps-domain)# erpi 1 protected-vlan add 4-6
Switch(config-erps-domain)#
Switch(config-erps-domain)# erpi 1 protected-vlan add 7,9
Switch(config-erps-domain)#
To Next Page
Loading...
