DGS-6604 m show gvrp statistics
CLI Reference Guide
608
show gvrp statistics
Use the show gvrp statistics command to display the statistics for gvrp ports.
show gvrp statistics [ interface INTERFACE-ID [ , | - ] ]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline It only displays the ports which have the gvrp state enabled.
Example This example shows how to display statistics for a range of gvrp ports.
Syntax Description
INTERFACE-ID (Optional) Specifies the interface to display. If no interface is specified, the
statistics on all interfaces will be shown.
, (Optional) Specifies a series of interfaces, or separate a range of interfaces from
a previous range.
- (Optional) Specifies a range of interfaces.
Switch# show gvrp statistics interface eth3.5-3.6
Port JoinEmpty JoinIn LeaveEmpty LeaveIn Empty
-----------------------------------------------------------------------------
eth3.5 . RX 0 0 0 0 0
TX 4294967296 4294967296 4294967296 4294967296 4294967296
eth3.6 . RX 0 0 0 0 0
TX 0 0 0 0 0
Total Entries: 2
To Next Page
Loading...
