DGS-6604 m show ip dvmrp neighbor
CLI Reference Guide
636
show ip dvmrp neighbor
Use this command to show DVMRP neighbor information.
show ip dvmrp neighbor [INTERFACE-ID | IP-ADDRESS] [detail]
Default None
Command Mode User EXEC or any configuration mode
Usage Guideline Use this command to display DVMRP neighbor information. If neither
INTERFACE-ID nor IP-ADDRESS is specified, then the information of all
neighbors will be displayed. If the keyword of detail is not specified, then only
brief information for the neighbors will be displayed.
Examples This example shows how to display neighbor information.
Display Field
Descriptions
Description of the significant display fields.
Syntax Description
INTERFACE-ID (Optional) Specifies the interface ID
IP-ADDRESS (Optional) The IP address of the neighbor
detail (Optional) Show the neighbor information in detail.
Switch>show ip dvmrp neighbor
Interface Neighbor Address Generation ID ExpTime
--------------- ---------------- ------------- -----------
vlan1 10.10.10.11 0035ef6d 0DT0H0M29S
Total Entries: 1
Display Field Description
Interface The interface refers to the routing interface which is mapped to a VLAN
interface.
Neighbor Address Once a system has received a Probe from a neighbor that contains the
system's address in the neighbor list, then the system has established a
two-way neighbor adjacency with this router.
Generation ID If a DVMRP router is restarted, it will not be aware of any previous prunes
that it had sent or received. In order for the neighbor to detect that the
router has restarted, a non-decreasing number is placed in the periodic
probe message called the generation ID. When a change in the
generation ID is detected, any prune information received from the router
is no longer valid and should be flushed.
To Next Page
Loading...
