DGS-6604 ip dhcp relay
CLI Reference Guide
253
ip dhcp relay
Use this command to enable Dynamic Host Configuration Protocol (DHCP) relay
agent features on the switch. Use the no form of this command to disable DHCP
relay agent features.
ip dhcp relay
no ip dhcp relay
Syntax None
Default Disabled
Command Mode Global configuration
Usage Guideline Use this command to enable DHCP relay function. The DHCP relay function is
disabled by default.
Example Enable DHCP relay function:
Verify the settings by entering the show ip dhcp relay command.
Switch > enable
Switch# configure terminal
Switch(config)# ip dhcp relay
To Next Page
Loading...
