DGS-6604 ipv6 ospf hello-interval
CLI Reference Guide
353
ipv6 ospf hello-interval
To specify the interval between hello packets sent from an interface, use the ipv6
ospf hello-interval command. To return to the default time, use the no form of
this command.
ipv6 ospf hello-interval SECONDS [instance-id INSTANCE-ID]
no ipv6 ospf hello-interval [instance-id INSTANCE-ID]
Default Seconds: 10
INSTANCE-ID: 0
Command Mode Interface configuration
Usage Guideline This value is advertised in the hello packets. The shorter the hello interval, the
earlier topological changes will be detected, but more routing traffic will ensue.
This value must be the same for all routers and access servers on a specific
network.
Example The following example sets the interval between hello packets to 15 seconds.
Syntax Description
SECONDS Specifies the interval in seconds. The value must be the same for all nodes on a
specific network. It can be a value in the range from 1 to 65535.
INSTANCE-ID (Optional) Instance identifier. To change this ID, configure the "no" command
first. The valid setting is from 0 to 255.
Switch > enable
Switch # configure terminal
Switch (config)# interface vlan1
Switch (config-if)# ipv6 ospf hello-interval 15
To Next Page
Loading...
