DGS-6604 ipv6 nd suppress-ra
CLI Reference Guide
349
ipv6 nd suppress-ra
This command is used to suppress IPv6 RA (router advertisement) on an
interface of this switch. Use the no ipv6 nd suppress-ra configuration command
to enable the sending of IPv6 router advertisements on an ISATAP tunnel
interface.
ipv6 nd suppress-ra
no ipv6 nd suppress-ra
Syntax None
Default Suppress RA
(Sending of IPv6 router advertisements is disabled by default on an ISATAP
tunnel interface)
Command Mode VLAN interface configuration
Usage Guideline The VLAN interface must be created first before this command can be used.
ISATAP tunnel interfaces are valid for this command. Other types of tunnel
interfaces are invalid.
Example This example shows how to suppress IPv6 RA’s:
Switch > enable
Switch # configure terminal
Switch (config) # interface vlan1
Switch (config-if) # ipv6 nd suppress-ra
To Next Page
Loading...
