DGS-6604 m gvrp timer
CLI Reference Guide
215
gvrp timer
Use the gvrp timer command to set the GVRP timer value for a port.
gvrp timer {join | leave | leave-all} TIMER-VALUE
Default join: 20
leave: 60
leave-all: 1000
Command Mode Interface configuration
Usage Guideline The value of these parameters must comply to the following rules:
1. LEAVE_TIMER >= 3 * JOIN_TIMER
2. LEAVE_ALL_TIMER > LEAVE_TIMER
Example This example shows how to set the leave-all timer to 5 seconds using the value
500 (hundredths of a second).
Verify the settings by entering the show gvrp configuration interface command.
Syntax Description
join Set the timer for joining the group. The unit is hundredths of a second.
leave Set the timer for leaving a group. The unit is hundredths of a second.
leave-all Set the time for leaving all groups. The unit is hundredths of a second.
TIMER-VALUE
<1-65535>
The timer value in hundredths of a second.
Switch(config)# interface eth3.1
Switch(config-if)# gvrp timer leave-all 500
To Next Page
Loading...
