DGS-6604 mm dot1x max-req
CLI Reference Guide
177
dot1x max-req
Use this command to set the maximum number of times that the switch sends
EAP-request/identity frames to the client before restarting the authentication
process.
dot1x max-req TIMES
Default TIMES: 2
Command Mode Interface configuration
Usage Guideline This command is only valid for physical port interface.
Example This example shows how to set the maximum number of retransmit times on port
eth4.1 to be 3.
Verify the settings with the show dot1x auth-configuration command.
Syntax Description
max-req TIMES Number of times that the switch retransmits an EAP frame to the client before
restarting the authentication process. The range is 1 to 10.
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# dot1x max-req 3
To Next Page
Loading...
