DGS-6604 m lacp port-priority
CLI Reference Guide
379
L
lacp port-priority
Use the lacp port-priority command to configure the port priority. Use the no
form to configure the port priority to the default.
lacp port-priority PRIORITY
no lacp port-priority
Default 32768
Command Mode Interface configuration
Usage Guideline The lacp port-priority command is used to specify which ports can join a port
channel and which ports are specified to be in backup mode. In a port priority
comparison, a numerically lower value has a higher priority. If two or more ports
have the same priority, the port number determines the priority.
Example This example shows how to configure the port priority to 20000 on interface
eth3.4 to eth3.5.
Verify the settings with the show channel-group command.
Syntax Description
PRIORITY Specifies the port priority. The range is 1 to 65535.
Switch(config)# interface range eth3.4-3.5
Switch(config-if)# lacp port-priority 20000
To Next Page
Loading...
