DGS-6604 mm dot1x re-authentication
CLI Reference Guide
181
dot1x re-authentication
Use this command to enable periodic re-authentication. Use the no form of this
command to disable periodic re-authentication.
dot1x re-authentication
no dot1x re-authentication
Syntax None
Default Disabled
Command Mode Interface configuration
Usage Guideline This command is valid only for physical port interface.
The number of seconds between re-authentication attempts can be configured
using the dot1x timeout command on page 183 with the reauth-period
keyword.
Examples This example enables periodic re-authentication on eth4.1.
This example shows how to disable periodic-re-authentication.
Verify the settings by entering the show dot1x auth-configuration command.
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# dot1x re-authentication
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# no dot1x re-authentication
To Next Page
Loading...
