DGS-6604 mm dot1x auth-protocol
CLI Reference Guide
170
dot1x auth-protocol
Use this command to specify the authentication method used for 802.1x
authentication.
dot1x auth-protocol {local | radius}
Default radius
Command Mode Global configuration
Usage Guideline If local is specified, a user account should be configured. Please refer to the
dot1x user command on page 184 to create new user accounts.
If radius is specified, a RADIUS server should be configured for authentication.
Please refer to the server command on page 541 in “AAA Feature
Commands” on page 1.
Example The following example shows how to specify the authentication method as
RADIUS.
Verify the settings by entering the show dot1x command on page 596.
Syntax Description
local Specifies local accounts for authentication
radius Specifies RADIUS servers for authentication
Switch# configure terminal
Switch(config)# dot1x auth-protocol radius
To Next Page
Loading...
