DGS-6604 mm dot1x system-auth-control
CLI Reference Guide
182
dot1x system-auth-control
Use dot1x system-auth-control to globally enable 802.1X authentication on a
switch. Use the no form of this command to return to globally disable 802.1X
function.
dot1x system-auth-control
no dot1x system-auth-control
Syntax None
Default Disabled
Command Mode Global configuration
Usage Guideline None
Examples This example shows how to globally enable 802.1X authentication on a switch.
This example shows how to disable 802.1x authentication globally on a switch.
Verify the settings by entering the show dot1x auth-configuration command.
Switch# configure terminal
Switch(config)# dot1x system-auth-control
Switch# configure terminal
Switch(config)# no dot1x system-auth-control
To Next Page
Loading...
