DGS-6604 mm dot1x default
CLI Reference Guide
172
dot1x default
Using this command resets the configurable 802.1X parameters to the default
values.
dot1x default
Syntax None
Default The default values are listed as following:
The authorization state on a controlled port is auto.
The direction of the traffic through a controlled port is bidirectional.
The number of maximum retransmit times which the switch will retransmit an
EAP request frame to the supplicant before restarting the authentication process
is 2.
The quiet-period, reauth-period, server-timeout, supp-timeout, and tx-period are
60, 3600, 30, 30, and 30 seconds, respectively.
Periodic re-authentication is disabled.
Command Mode Interface configuration
Usage Guideline This command is only valid on physical port interface.
Example The following example shows how to reset the IEEE 802.1X parameters on port
eth4.1.
Verify the settings by entering the show dot1x auth-configuration command.
Switch# configure terminal
Switch(config)# interface eth4.1
Switch(config-if)# dot1x default
To Next Page
Loading...
